ULTIMATE 300

WINGSPAN: 62 inches          FUSELAGE LENGTH: 67 inches          WING AREA: 1270 square inches

WEIGHT: (4C-120) 11 lbs.          POWER: 2 stroke 1.08 - 1.8

The ULTIMATE 300 prototype was powered by an Enya R 120 4 stroke.  It weighed only 11 pounds and flew exceptionally well even in the hot thin air at 5,000 ft. in Zimbabwe.  With a 2 stroke 1.08 the weight could be reduced to 10.5 pounds and the span cut to 59 inches without any loss of performance.  If unlimited vertical performance is required the airplane can also be fitted with a MOKI 1.8.  The front end of the framed balsa fuselage is reinforced internally with epoxyglass to allow a heavier engine to be fitted to the 8" wide firewall.  It also fuel proofs the tank bay.  Four identical panels of th ebalsa sheeted foam core wings are supplied with the sweep angle built in and ready for joining.  The flat plate stab and fin plus the elevators and rudder are balsa framed and sheeted ready for covering.  The distinctive interplane struts are machined to shape and the aluminum cabane parts are prebent.  Top and bottom wings attach to the cabane and to the fuselage with nylon bolts and the wing struts are fixed with two cap screws.  The sturdy aluminum alloy landing gear bolts to the fuselage bottom.  The kit also includes epoxy wheel pants and cowl and an illustrated instruction manual.

MADE ENTIRELY IN THE USA BY TENNESSEE CRAFTSMEN

For full details of this model & other ARF Kits available e-mail, call or write to:

Tennessee Model Products
P.O. Box 5776
Oak Ridge, Tennessee  37831
Technical Information 865-482-6188